config inline-power reserved budget
ExtremeWare Software 7.3.0 Command Reference Guide 1907
config inline-power reserved budget
config inline-power reserved budget <milliwatts> ports <portlist>
Description
Sets the reserved power on the specified ports to either the default value or the specified watts.
Syntax Description
Default
0 mW.
Usage Guidelines
This command sets the reserved power on the specified ports to either the default value or the specified
watts. The reserved power range is 0 or 3000-20000 mW. The default reserved power range value is 0
mW. Total power reserved may be up to but not greater than the total power for the card. If all of the
power available to the card is reserved, then the common power pool is empty.
Example
The following command sets the reserved power for all the ports on slot 4 to 15000 mW:
config inline-power reserved budget 15000 ports 4:*
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
milliwatts An integer specifying milliwatts at zero (0) or in the range of 3000 – 20000 mW.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...
Need help?
General
