124 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
configure snmp sysName
configure snmp sysname <alphanumeric string>
Description
Configures the name of the switch.
Syntax Description
Default
The default
sysname
is the model name of the device (for example,
Summit1
).
Usage Guidelines
You can use this command to change the name of the switch. A maximum of 32 characters is allowed.
The
sysname
appears in the switch prompt.
To view the name of the system listed on the switch, use the
show switch
command. The
show switch
command displays switch statistics including the name of the system.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
configure snmp sysname <alphanumeric string>
command, use the
unconfigure management
command.
Example
The following command names the switch:
configure snmp sysname engineeringlab
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
alphanumeric string Specifies a device name.
To Next Page
Loading...