disable icmp parameter-problem
ExtremeWare Software 7.3.0 Command Reference Guide 1189
disable icmp parameter-problem
disable icmp parameter-problem {vlan <vlan name>}
Description
Disables the generation of an ICMP parameter-problem message on one or all VLANs.
Syntax Description
Default
Enabled.
Usage Guidelines
Disables the generation of an ICMP parameter-problem message (type 12) when the switch cannot
properly process the IP header or IP option information. If a VLAN is not specified, the command
applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command disables the generation of an ICMP parameter-problem message on VLAN
accounting:
disable icmp parameter-problem vlan accounting
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
To Next Page
Loading...
Need help?
General
