952 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
unconfigure cpu-dos-protect
unconfigure cpu-dos-protect
Description
Resets denial of service protection configuration to default parameter values.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command will not change whether denial of service protection is enabled or disabled. To enable or
disable denial of service protection, use the following commands:
enable cpu-dos-protect
disable cpu-dos-protect
The default values for the denial of service protection parameters are as follows:
• alert-threshold—4000 packets per second
• notice-threshold—4000 packets per second
• timeout—15 seconds
• messages—on (messages are sent to syslog)
• filter-precedence—10
Example
The following command resets the denial of service protection configuration to the default values:
unconfigure cpu-dos-protect
History
This command was first available in ExtremeWare 7.0.0
Platform Availability
This command is available on all platforms.
To Next Page
Loading...