1276 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
configure isis vlan
configure isis [vlan <vlan name> | all] [level-1| level-2 | level-1-2]
[passive | non-passive]
Description
Configures the different IS-IS levels on a routing interface as passive or non-passive.
Syntax Description
Default
By default, all the routing interfaces are non-passive.
Usage Guidelines
If
all
is specified, all routing interfaces in the system are configured as passive or non-passive.
When a level on an interface is configured as passive, the corresponding Hello packets are not sent or
received on that interface. Any packet that is received is ignored. As result of this no adjacency is
established.
Example
The following command configures vlan v1 as a level 2 passive interface
configure isis vlan v1 level-2 passive
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
vlan name Specifies the name of a VLAN.
all Specifies all VLANs.
level-1 Specifies IS-IS level 1.
level-2 Specifies IS-IS level 2.
level-1-2 Specifies IS-IS level 1 and level 2.
passive Specifies passive.
non-passive Specifies non-passive.
To Next Page
Loading...
Need help?
General
