enable slb gogo-mode ping-check
ExtremeWare Software 7.3.0 Command Reference Guide 559
enable slb gogo-mode ping-check
enable slb gogo-mode <port number> ping-check <ip address>
Description
Enables layer-3 ping-check for the GoGo mode group.
Syntax Description
Default
GoGo mode ping check is disabled by default.
Usage Guidelines
GoGo mode ping-check sends a ping from each physical port in the GoGo mode grouping to the
configured IP address.
If you do not specify an IP address, GoGo mode ping-check uses the previously configured IP address.
You must enable GoGo mode for the group before you enable ping-check. To enable GoGo mode, use
the following command:
enable slb gogo-mode
To disable ping-check for a GoGo mode group, use the following command:
disable slb gogo-mode <port number> ping-check
Example
The following command enables GoGo mode ping-check for the group with port 29 as the master port
to IP address 10.10.200.3:
enable slb gogo-mode 29 ping-check 10.10.200.3
History
This command was first available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
port number Specifies the GoGo mode master port.
ip address Specifies an IP address to be pinged.
To Next Page
Loading...
Need help?
General
