enable slb node
ExtremeWare Software 7.3.0 Command Reference Guide 565
enable slb node
enable slb node [all | <ip address> : [ftp | http | https | imap4 | ldap |
nntp | pop3 | smtp | socks | telnet | tftp | web | wildcard | www | <TCP or
UDP port number>]]
Description
Enables one or all nodes.
Syntax Description
Default
Nodes are enabled by default.
Usage Guidelines
This command allows nodes to accept new connections.
To disable a node, use the following command:
disable slb node
Example
The following command enables all nodes:
enable slb node all
all Specifies all nodes.
ip address Specifies an IP address.
ftp Specifies an FTP node.
http Specifies an HTTP node.
https Specifies an HTTPS node.
imap4 Specifies an IMAP4 node.
ldap Specifies an LDAP node.
nntp Specifies an NNTP node.
pop3 Specifies a POP3 node.
smtp Specifies an SMTP node.
socks Specifies a SOCKS node.
telnet Specifies a telnet node.
tftp Specifies a TFTP node.
web Specifies a Web node.
wildcard Specifies any port associated with a wildcard server.
www Specifies a www node
TCP or UDP port number Specifies a TCP or UDP port for the node.
To Next Page
Loading...
Need help?
General
