Extreme Networks ExtremeWare - Show Wireless Ports Interface Configuration

show wireless ports interface configuration
ExtremeWare Software 7.3.0 Command Reference Guide 2095
show wireless ports interface configuration
show wireless ports [<portlist> | all] interface [1 | 2] configuration
{detail}
Description
Displays information about wireless configuration for the selected ports and interface.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to show in table or list format the configuration and state of the interface of the
selected port or ports.
Examples
The following example displays information about the wireless port configuration for ports 1:26-1:30
and interface 1:
show wireless ports 1:26-1:30 interface 1 configuration
Output of the command is similar to:
Port Intf State RF Prof. Sec. Prof. TxRate Power Chan. Max Cl. Bridging
-------------------------------------------------------------------------------
1:26 1 EN rf_26 Unsecure 54 FULL 0 100 EN
1:27 1 EN rf_27 Unsecure 54 FULL 0 100 EN
1:28 1 EN rf_28 Unsecure 54 FULL 0 100 EN
1:29 1 EN DEFAULT_A Unsecure 54 FULL 0 100 EN
1:30 1 EN DEFAULT_A Unsecure 54 FULL 0 100 EN
EN- Enabled, DIS - Disabled
The following example shows the extra details shown when the keyword detail is added to the
command:
show wireless ports 1:26-1:30 interface 1 configuration detail
The detailed output is similar to:
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail Specifies that information should be displayed in detailed format.