78 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Accessing the Switch
configure idletimeouts
configure idletimeouts <minutes>
Description
Configures the time-out for idle HTTP, console, and Telnet sessions.
Syntax Description
Default
Default time-out is 20 minutes.
Usage Guidelines
This command configures the length of time the switch will wait before disconnecting idle HTTP,
console, or Telnet sessions. The idletimeouts feature must be enabled for this command to have an effect
(the idletimeouts feature is disabled by default).
In ExtremeWare v 6.2.0, the time-out interval was specified in seconds, not minutes.
Example
The following command sets the time-out for idle HTTP, login and console sessions to 10 minutes:
configure idletimeouts 10
History
This command was first available in ExtremeWare 6.2.
This command was modified in ExtremeWare 6.2.1 to change the time-out value specification to
minutes.
Platform Availability
This command is available on all platforms.
minutes Specifies the time-out interval, in minutes. Range is 1 to 240 (1 minute to 4
hours).
To Next Page
Loading...
Need help?
General
