unconfigure aps
ExtremeWare Software 7.3.0 Command Reference Guide 1689
unconfigure aps
unconfigure aps <group#>
Description
Resets the APS group configuration parameters to their default values.
Syntax Description
Default
N/A.
Usage Guidelines
You specify the
group#
parameter, which is an integer in the range [1-65535]. The
group#
identifies the
APS group that the command applies to. The command does not affect the ports that have been added
to the APS group. The command does cancel any outstanding lockout, force, or manual switch requests.
Example
The following command example resets the configuration parameters of APS group
1001
to their
default values:
unconfig aps 1001
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
group# Specifies the APS group# to which the command applies.
To Next Page
Loading...
Need help?
General
