2086 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface client-history status
show wireless ports [<portlist> | all] interface [1 | 2] client-history
status
Description
Displays the current status of the historical client information.
Syntax Description
Default
N/A.
Usage Guidelines
This command displays information about the client diagnostic and history database. The output has
the following fields:
Example
The following example displays the client diagnostic information for port 1 and interface 1:
show wireless ports 1 interface 1 client-history status
The output of the command is similar to:
Intf Enabled TableSize Timeout CurrSize Watermark Overflows Ageouts
----------------------------------------------------------------
1:1 N 128 600 0 0 0 0
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
Field Description
Enable This value indicates if historical information is being collected on this interface or
not.
TableSize This is the number of entries allowed in each of the historical client tables.
Timeout This is the time, in seconds, that entries will persist in the historical client tables
after the referenced client is removed from the SIB.
CurrentSize The current number of entries in the historical client database
Watermark The maximum number of entries which have ever been in the historical client
database.
Overflows Number of entries which have been overwritten in order to make room for a new
entry.
AgeOuts Number of entries which have been aged out of the table
To Next Page
Loading...