Extreme Networks ExtremeWare - Show Mpls Rsvp-Te Lsp

show mpls rsvp-te lsp
ExtremeWare Software 7.3.0 Command Reference Guide 1843
show mpls rsvp-te lsp
show mpls rsvp-te lsp {<lsp_name>} {detail}
Description
Displays the RSVP-TE LSP.
Syntax Description
Default
N/A.
Usage Guidelines
This command displays the configuration and status information for RSVP-TE LSPs. Information is
listed in tabular format and includes the LSP name, LSP state, active path name, bandwidth requested,
bandwidth actually reserved, ERO flag, egress LSR, LSP up-time, and RSVP error codes (if LSP setup
failed). If you specify a specific LSP name, only information for the specified LSP is displayed. If you
specify the optional
detail keyword, additional information is displayed for each LSP. The detailed
information includes a list of all configured paths, including the path state, error codes for the LSP
associated with each path, up-time for each LSP, the bound profile name, and a list of TLS tunnels
configured to use the LSP.
Example
The following displays the configuration and status information for all configured RSVP-TE LSPs in
detailed format:
show mpls rsvp-te lsp detail
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
lsp_name Specifies the name of the LSP.
detail Specifies to display the information in detailed format.