172 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
enable alt-queue-management
enable alt-queue-management
Description
Enables the Alternative Queue Management (Alt-Queue Management).
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
Use this command to enable the Alt-Queue Management feature for the next boot. Configuring the
feature does not affect the queue management of the current boot.
Use the
show switch
command to display the Alt-Queue Management feature status, as shown in the
following example:
MSM64:3 # show switch
SysName: MSM64
SysLocation:
SysContact: support@extremenetworks.com, +1 888 257 3000
System MAC: 00:01:30:12:2A:D0
License: Full L3
System Mode: 802.1Q EtherType is 8100 (Hex).
Diag Mode: Fast Post
RED Probability: 0 Marked Probability: 0
DLCS: Disabled
Backplane Ls: port-based
SysHealth Check: Enabled. Alarm Level = Log
Recovery Mode: None
Transceiver Diag: Enabled. Failure action: log only
Fdb-Scan Diag: Enabled. Failure action: sys-health-check
MSM Failover: take-links-down
System Watchdog: Enabled
Reboot Loop Prot: Disabled
Alter Queue Mgmt: Disabled Next Boot: Disabled
Bus-stats: Disabled
Current Time: Wed Oct 29 18:58:17 2003
Timezone: [Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently not in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Press <SPACE> to continue or <Q> to quit:
To Next Page
Loading...
Need help?
General
