use image
ExtremeWare Software 7.3.0 Command Reference Guide 2131
use image
use image [primary | secondary] {slot <slot>}
Description
Configures the switch to use a saved image on the next reboot.
Syntax Description
Default
Primary.
Usage Guidelines
None.
Example
The following command configures the switch to use the primary image on the next reboot:
use image primary
History
This command was first available in ExtremeWare 2.0.
Support for the
<slot>
parameter was introduced in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
primary Specifies the primary saved software image.
secondary Specifies the secondary saved software image.
slot Specifies a saved image in the module in the specified slot.
To Next Page
Loading...