Extreme Networks ExtremeWare - Show Wireless Ports Log

2104 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports log
show wireless ports [<portlist>| all] log
Description
Displays the local Altitude 300 event log of the selected port or ports.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display the Altitude 300 local log for debugging errors.
Examples
The following command displays log information for port 3 on the device:
show wireless ports 3 log
The output of the command is similar to:
Log Servers for port 3 :
Server 192.168.1.244:514, Facility local0, Severity info
[3] Jul 26 17:51:06 :2 Client 00:0C:41:2B:E4:27 aged out (name
"OPEN:labupda@labuwifi.com")
[3] Jul 26 17:40:58 :2 DOT1X 00:0C:41:2B:E4:27 Exhausted retries on RADIUS servers.
[3] Jul 26 17:40:52 Failed with primary radius server. Trying secondary.
[3] Jul 26 17:40:32 :2 DOT1X 00:0C:41:2B:E4:27 Exhausted retries on RADIUS servers.
[3] Jul 26 17:40:26 Failed with primary radius server. Trying secondary.
[3] Jul 26 17:40:00 :2 DOT1X 00:0C:41:2B:E4:27 Exhausted retries on RADIUS servers.
[3] Jul 26 17:39:54 Failed with primary radius server. Trying secondary.
[3] Jul 26 17:20:41 :2 Client 00:0D:88:C2:4D:AC Auth Failed (name "802.1x:unknown")
[3] Jul 26 17:19:10 :2 Client 00:0D:88:C2:4D:AC Auth Failed (name "802.1x:unknown")
[3] Jul 26 17:17:36 :2 Client 00:0D:88:C2:4D:AC Auth Failed (name "802.1x:unknown")
[3] Jul 26 17:15:18 :2 Radio channel updated to AUTO
[3] Jul 26 17:15:18 :2 Radio channel updated to 4
[3] Jul 26 17:15:10 :2 Radio Interface Enabled
[3] Jul 26 17:15:10 :1 Radio channel updated to AUTO
[3] Jul 26 17:15:10 :1 Radio channel updated to 52
[3] Jul 26 17:14:59 :1 Radio Interface Enabled
[3] Jul 26 17:14:57 :2 SSID updated to fz-dot1x-128
[3] Jul 26 17:14:57 :1 SSID updated to fz-wpa-psk-aes
[3] Jul 26 17:14:56 :2 WEP Encryption Mode set to 128-BIT Encryption
[3] Jul 26 17:14:56 :1 WEP Encryption Mode set to 128-BIT Encryption
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.