Extreme Networks ExtremeWare - Configure Vlan Esrp Esrp-Premaster-Timeout

configure vlan esrp esrp-premaster-timeout
ExtremeWare Software 7.3.0 Command Reference Guide 1095
configure vlan esrp esrp-premaster-timeout
configure vlan <vlan name> esrp esrp-premaster-timeout <premaster-timer
(0-512, 0 restores dflt)>
Description
Configures the ESRP pre-master timeout value.
Syntax Description
Default
The default timeout is 6 seconds (three times the hello timer).
Usage Guidelines
The premaster-timer range is 0 - 512. If you set the premaster-timer to 0, ESRP uses the default. To
see the
premaster-timer settings, use the show esrp vlan command.
CAUTION
Configure the pre-master state timeout only with guidance from Extreme Networks personnel.
Misconfiguration can severely degrade the performance of ESRP and your switch.
Example
The following command configures the pre-master timeout to 10 seconds for the VLAN esrp-1 :
configure vlan esrp-1 esrp esrp-premaster-timeout 10
History
This command was first available in ExtremeWare 7.1.0, and replaced the configure vlan esrp
esrp-neutral-timeout
command.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
premaster-timer Specifies the maximum length of time, in seconds, that the transitioning
master VLAN remains in the pre-master state. The range is 0 to 512.