disable inline-power slots
ExtremeWare Software 7.3.0 Command Reference Guide 1913
disable inline-power slots
disable inline-power slots <slot_id>
Description
Disables power provided to the specified slot.
Syntax Description
Default
Enable.
Usage Guidelines
You can control whether inline power is provided to a specific slot by using the disable inline-power
slots <slot_id> command and the enable inline-power slots <slot_id> command. Using the disable
inline-power slots <slot_id> command shuts down power currently provided to the selected slot. The
system defaults to enabling power on all slots.
To power any port, the following conditions must be met:
• The system must be enabled for power.
• The slot must be enabled for power.
• The ports must be enabled for power.
Disabling a slot providing power to a powered device (PD) through one of its powered ports
immediately removes power to the PD.
Example
The following command shuts down power currently provided by slot 2:
disable inline-power slots 3
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
slot_id Specifies the slot for which power will be disabled.
To Next Page
Loading...