1400 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
configure bgp add network
configure bgp add network <ip address>/<mask length> {<route map>}
Description
Adds a network to be originated from this router.
Syntax Description
Default
N/A.
Usage Guidelines
The network must be present in the routing table.
Using the
export
command to redistribute routes complements the redistribution of routes using the
configure bgp add network
command. The
configure bgp add network
command adds the route
to BGP only if the route is present in the routing table. The
enable bgp export
command redistributes
an individual route from the routing table to BGP. If you use both commands to redistribute routes, the
routes redistributed using the
network
command take precedence over routes redistributed using the
export
command.
Example
The following command adds a network to be originated from this router:
configure bgp add network 192.1.1.16/12
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
mask length Specifies a netmask length.
route map Specifies a route map.
To Next Page
Loading...