configure debug-trace slb-3dns
ExtremeWare Software 7.3.0 Command Reference Guide 2191
configure debug-trace slb-3dns
configure debug-trace slb-3dns <debug level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for SLB 3DNS errors to 3:
configure debug-trace slb-3dns 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — Records serious errors that can cause 3DNS support to fail. This includes
problems associated with system resources, invalid iQuery messages, and
internal SLB and 3DNS table maintenance.
1 — Records task and or socket layer errors. These errors might indicate other more
serious problems.
2 — Records informational 3DNS member change notifications, state changes, or
age-outs.
3 — Decodes and displays incoming and outgoing 3DNS iQuery messages. Also
displays some internal table data when the 3DNS member entries are created or
updated.
4 — No additional information recorded.
5 — No additional information recorded.
To Next Page
Loading...
Need help?
General
