Extreme Networks ExtremeWare User Manual

1218 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
enable icmp timestamp
enable icmp timestamp {vlan <vlan name>}
Description
Enables the generation of an ICMP timestamp response on one or all VLANs.
Syntax Description
Default
Enabled.
Usage Guidelines
Enables the generation of an ICMP timestamp response (type 14, code 0) when an ICMP timestamp
request is received. If a VLAN is not specified, the command applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command enables the generation of an ICMP timestamp response on VLAN accounting:
enable icmp timestamp vlan accounting
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.

Extreme Networks ExtremeWare Specifications

General

Vendor	Extreme Networks
Compatibility	Extreme Networks switches and routers
Type	Network Operating System
Functionality	Network management
User Interface	CLI
Protocols Supported	OSPF, BGP, RIP, VLAN, STP
Features	QoS, Security Features