1878 ExtremeWare Software 7.3.0 Command Reference Guide
High Density Gigabit Ethernet Commands
enable diagnostics cable
enable diagnostics cable port [<portlist> | all]
Description
Enables the automatic running of the Cable Diagnostics Module (CDM) to obtain cable diagnostics
values for selected physical ports of the system.
Syntax Description
Default
None.
Usage Guidelines
This command enables the automatic running of cable diagnostics for selected physical ports of the
system. To set the starting time for auto-diagnostics collection for selected ports, use the
configure
diagnostics cable
command. To disable auto-diagnostics collection for selected ports, use the
disable diagnostics cable
command. To manually run cable diagnostics, use the
run diagnostics
cable
command. To abort cable diagnostics current in progress, use the
abort diagnostics cable
command.
You cannot issue this command while the cable diagnostics process is in progress.
To view cable diagnostics data, use the
show diagnostics cable
command.
Example
The following command enables automatic running of cable diagnostics for all ports.
enable diagnostics cable port all
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on
“3”
series I/O modules only.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
all Specifies all
“3”
series ports.
To Next Page
Loading...
Need help?
General
