show management
ExtremeWare Software 7.3.0 Command Reference Guide 193
show management
show management
Description
Displays the SNMP settings configured on the switch.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines:
The following show management output is displayed:
• Enable/disable state for Telnet, SNMP, and web access
• SNMP community strings
• Authorized SNMP station list
• SNMP trap receiver list
• Login statistics
For ExtremeWare 4.0 and higher, the following show management output is also displayed:
• Enable/disable state for SSH2 and access profile information
• RMON polling configuration
For ExtremeWare 6.2.2 and higher, the enable/disable state of the port-up-down traps is also displayed.
For ExtremeWare 7.0.0 and higher, the enable/disable state of the mac-limit traps is also displayed.
For ExtremeWare 7.1.0 and higher, the SNMP access display item will show the additional states of v1,
v2c disabled and v3 enabled. The flags field was enhanced to show the SNMP trap groups.
Example
The following command displays configured SNMP settings on the switch:
show management
Following is the output from this command:
To Next Page
Loading...