Extreme Networks ExtremeWare - Page 194

194 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
CLI idle timeouts: disabled
CLI Paging: enabled
CLI configuration logging: enabled
Telnet access: enabled tcp port: 23
Web access: enabled tcp port: 80
Web access login timeout : 30 secs
SSH Access: key invalid, disabled tcp port: 22
UDP Echo Server: disabled udp port: 7
SNMP Access: v1v2c disabled ; v3 enabled
SNMP Read Only Communities: rykfcb
Total Read Only Communities: 1
SNMP Read Write Communities: r~`|kug
Total Read Write Communities: 1
SNMP dot1dTpFdbTable: disabled
RMON polling: disabled
SNMP Traps: enabled
SNMP v1/v2c TrapReceivers:
Destination Community Source IP Address Flags
10.255.254.22 /162 public 2EA
111.111.111.111/162 ThisIsATestComm 2SA
Flags: Version: 1=v1 2=v2c
Mode: S=Standard E=Enhanced
Trap Groups: s=STP b=BGP o=OSPF p=Ping/Traceroute v=VRRP y=System
e=Extreme m=Smart Traps a=Auth l=Link Up/Down r=RMON
c=Security
A=All
SNMP MAC Security traps: disabled
Link Up/Link Down traps enabled on ports: All, including MgmtPort
SNMP stats: inPkts 301 outPkts 302 errors 0 authErrors 0
Gets 93 GetNexts 208 Sets 0
SNMP traps: sent 10 authTraps enabled
Login stats:
validLogins 3 badPasswords 0 unknownUSers 2(last bad user: admin1)
Telnet: total 3 valid 1 invalid 2
HTTP: total 0 valid 0 invalid 0
Management access stats:
Protocol UDP/TCP Port Total packets Rejected packets
-- -- -- -- --
Protocol Soures IP Address UDP/TCP Port Time
-- -- -- -- --
History
This command was first available in ExtremeWare 2.0.
Support for the SSH2 state, access profile information and RMON polling configuration was introduced
in ExtremeWare 4.0.
Additional information on traps configured per port port-up-down traps was added in ExtremeWare
6.2.2.
Additional information on mac-limit traps was added in ExtremeWare 7.0.0