Extreme Networks ExtremeWare - Configure Slb Esrp Vlan

configure slb esrp vlan
ExtremeWare Software 7.3.0 Command Reference Guide 453
configure slb esrp vlan
configure slb esrp vlan <vlan name> [add | delete] unit [number]
Description
Configures all virtual servers with the specified unit number to match the state of the specified ESRP
VLAN.
Syntax Description
Default
The default is unit 1.
Usage Guidelines
You must configure ESRP for the VLAN that you specify.
Virtual servers added with a unit number that is already configured for ESRP failover automatically
match the ESRP state configured for that unit number.
Use the unit number to associate a group of virual servers with an ESRP VLAN so that ESRP controls
the failover state of the virtual servers. To set the unit number of a virtual server, use the following
command:
configure slb vip
For simplicity, Extreme Networks recommends that you put client, server, and virtual server VLANs in
the same ESRP group.
Example
The following command configures ESRP VLAN “servers” to control the failover state of all virtual
servers configured with unit 3:
configure slb esrp vlan servers add unit 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vlan name Specifies an ESRP VLAN.
unit Specifies a unit identifier on a virtual server. The range is 1 to 16.