1034 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
enable stpd rapid-root-failover
enable stpd <spanning tree name> rapid-root-failover
Description
Enables rapid root failover for faster STP recovery times.
Syntax Description
Default
Disabled.
Usage Guidelines
To view the status of rapid root failover on the switch, use the
show stpd
command. The
show stpd
command displays information about the STPD configuration on the switch including the
enable/disable state for rapid root failover.
Example
The following command enables rapid root fail over on STPD Backbone_st:
enable stpd backbone_st rapid-root-failover
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
To Next Page
Loading...