configure pim register-checksum-to
ExtremeWare Software 7.3.0 Command Reference Guide 1515
configure pim register-checksum-to
configure pim register-checksum-to [include-data | exclude-data]
Description
Configures the checksum computation to either include data (for compatibility with Cisco Systems
products) or to exclude data (for RFC-compliant operation), in the register message.
Syntax Description
Default
Include data
Usage Guidelines
None.
Example
The following command configures the checksum mode to include data for compatibility with Cisco
Systems products:
configure pim register-checksum-to include-data
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
include-data Specifies to include data.
exclude-data Specifies to exclude data.
To Next Page
Loading...