730 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
show packet-mem-scan-recovery-mode
show packet-mem-scan-recovery-mode
Description
Displays the recovery mode setting for slot’s that have packet memory scanning enabled.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
The
show packet-mem-scan-recovery-mode
command displays the following information:
• Global settings for the system health check
• Auto-recovery settings for slots that have packet memory scanning enabled
Example
The following command displays the settings for each slot that has packet memory scanning enabled:
show packet-mem-scan-recovery-mode
The following is sample output from this command:
Global sys-health-check 'online' setting is ONLINE
slot 3: AUTORECOVERY MODE is OFFLINE
MSM-B: AUTORECOVERY MODE is ONLINE
# NOTE Global setting is always online for sys-health-check alarm-level
configurations.
It is only offline when "sys-health-check auto-recovery <#> offline" is
configured.
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on BlackDiamond switches only.
To Next Page
Loading...
Need help?
General
