438 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
clear slb connections
clear slb connections {ipaddress <ip address> : <port> | vip <vip name>}
Description
Clears all existing SLB connections.
Syntax Description
Default
N/A.
Usage Guidelines
If you do not specify an IP address or a virtual server, all connections are cleared.
This interrupts all current connections, but does not prevent new connections from being established. To
prevent new connections from being established, disable SLB to each virtual server using the following
command:
disable slb vip <vip name> all
To prevent new connections from being established to a specific virtual server and simultaneously close
all current connections, use the following command:
disable slb vip <vip name> all close-connections-now
Example
The following command clears the connections to the virtual server “content”:
clear slb connections content
History
This command was available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
port Specifies a port.
vip name Specifies a virtual server.
To Next Page
Loading...