356 ExtremeWare Software 7.3.0 Command Reference Guide
FDB Commands
configure fdb agingtime
configure fdb agingtime <seconds>
Description
Configures the FDB aging time for dynamic entries.
Syntax Description
Default
300 seconds.
Usage Guidelines
The range is 15 through 1,000,000 seconds.
If the aging time is set to zero, all aging entries in the database are defined as static, nonaging entries.
This means that they do not age out, but non-permanent static entries can be deleted if the switch is
reset.
Example
The following command sets the FDB aging time to 3,000 seconds:
configure fdb agingtime 3000
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
seconds Specifies the aging time in seconds. Range is 15 through 1,000,000. A value
of 0 indicates that the entry should never be aged out.
To Next Page
Loading...
Need help?
General
