1432 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
configure bgp peer-group next-hop-self
configure bgp peer-group <peer group> [next-hop-self | no-next-hop-self]
Description
Configures the next hop address used in the updates to be the address of the BGP connection
originating the update.
Syntax Description
Default
N/A.
Usage Guidelines
These settings apply to the peer group and all neighbors of the peer group.
Example
The following command configures the next hop address used in the updates to be the address of the
BGP connection originating it:
configure bgp peer-group outer next-hop-self
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
peer group Specifies a peer group.
next-hop-self Specifies that the next hop address used in the updates be the address of the
BGP connection originating it.
no-next-hop-self Specifies that the next hop address used in the updates not be the address of
the BGP connection originating it.
To Next Page
Loading...
Need help?
General
