128 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
configure snmpv3 add filter
configure snmpv3 add filter {hex} <profile name> subtree <object
identifier> {/<subtree mask>} type [included | excluded] {volatile}
Description
Add a filter to a filter profile.
Syntax Description
Default
The default
mask
value is an empty string (all 1s). The other default value is
non-volatile
.
Usage Guidelines
Use this command to create a filter entry in the snmpNotifyFilterTable. Each filter includes or excludes a
portion of the MIB. Multiple filter entries comprise a filter profile that can eventually be associated with
a target address. Other commands are used to associate a filter profile with a parameter name, and the
parameter name with a target address.
This command can be used multiple times to configure the exact filter profile desired.
Example
Use the following command to add a filter to the filter profile prof1 that includes the MIB subtree
1.3.6.1.4.1/f0:
configure snmpv3 add filter prof1 subtree 1.3.6.1.4.1/f0 type included
History
This command was first available in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
profile name Specifies the filter profile that the current filter is added to.
object identifier Specifies a MIB subtree.
subtree mask Specifies a hex octet string used to mask the subtree. For example, f7a
indicates 1.1.1.1.0.1.1.1.1.0.1.0.
included Specifies that the MIB subtree defined by <object identifier>/<mask> is to be
included.
excluded Specifies that the MIB subtree defined by <object identifier>/<mask> is to be
excluded.
volatile Specifies volatile storage.
To Next Page
Loading...