Extreme Networks ExtremeWare - Configure Isis Area Domain-Filter

configure isis area domain-filter
ExtremeWare Software 7.3.0 Command Reference Guide 1265
configure isis area domain-filter
configure isis area <isis area identifier> domain-filter [<access profile>
| none]
Description
Configures an access profile to filter the IP reachability information from this level 1 area that will be
included in the level 2 LSP:
Syntax Description
Default
N/A.
Usage Guidelines
When an access profile is not configured, none of the information is filtered. By default, no access
profile is present on a level 1 area.
Example
The following command configures access profile ap1 as the domain filter for the area a1:
configure isis area a1 domain-filter ap1
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
isis area identifier Specifies an area identifier.
access profile Specifies an access profile name.
none Specifies no access profile.