configure security-profile use-dynamic-vlan
ExtremeWare Software 7.3.0 Command Reference Guide 821
configure security-profile use-dynamic-vlan
configure security-profile <name> use-dynamic-vlan {y | n}
Description
Determines whether the security profile uses the dynamic VLAN (VLAN pushed by the RADIUS server
through a VSA (Vendor Specific Attribute)).
Syntax Description
Default
Y (yes).
Usage Guidelines
If the variable is set to
Y
(yes), and if the RADIUS server is configured to push back VSA 203 or 209,
then the pushed-back VSAs will override the
default-user-vlan
setting. (If both VSAs are
configured, then they have to point to the same VLAN.) The user will be placed in the VLAN indicated
by the VSA after authentication.
If the variable is set to
N
(no), then the user will be placed in the VLAN indicated by
default-user-vlan
regardless of any VSAs from the RADIUS srever.
Use the following command to configure the
default-user-vlan
:
configure security-profile <name> default-user-vlan <vlan>
Example
The following example sets the security profile, open-profile, to use the dynamic VLAN:
configure security-profile open-profile use-dynamic-vlan y
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
name Specifies the names of the security profile.
y Specifies y for yes to use the dynamic VLAN. The default is y (yes).
n Specifies n for no to not use the dynamic VLAN.
To Next Page
Loading...
Need help?
General
