enable flowstats ports
ExtremeWare Software 7.3.0 Command Reference Guide 691
enable flowstats ports
enable flowstats ports <portlist>
Description
Enables the flow statistics function on the specified ports.
Syntax Description
Default
Disabled.
Usage Guidelines
On the PoS module, flow statistics are only collected on SONET ports that are configured to use the IP
control protocol, IPCP, (in other words, flow statistics are not collected on ports that are configured to
use the bridging control protocol, BCP). Also, there are no configuration restrictions that prohibit
enabling of the flow statistics function on ports that are not configured to use IPCP; statistics are not
collected on those ports.
Example
The following command enables the ping-check function for all export groups.
enable flowstats ping-check
History
This command was first available in ExtremeWare 6.1.5b20 for the PoS module
This command was made available in ExtremeWare 6.2 for all “i” series platforms.
Platform Availability
This command is available on all platforms.
portlist Specifies a list of ports or slots and ports for which the flowstats function
should be enabled. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
To Next Page
Loading...
Need help?
General
