1946 ExtremeWare Software 7.3.0 Command Reference Guide
H-VPLS Commands
configure mpls ldp acl add peer
config mpls ldp acl add [peer <ipaddress> | <host_name>]
Description
Adds an LDP peer to the ACL.
Syntax Description
Default
N/A.
Usage Guidelines
This command adds an LDP peer to the ACL. The acl keyword is used to configure an LDP peer that is
allowed to establish LDP peer session with this LSR. Up to 256 peers may be configured. The
ipaddress
parameter identifies the peer from which targeted and non-targeted LDP sessions are
accepted. If the peer is specified using the
host_name
parameter, the DNS client must be configured so
that the
host_name
can first be resolved to an IP address. LDP Hellos from IP addresses that are not
included in the acl list are ignored.
Example
None.
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch.
ipaddress Identifies the peer from which targeted and non-targeted LDP sessions are
accepted.
host_name Identifies the peer. Must be able to be resolved to an IP address.
To Next Page
Loading...
Need help?
General
