1680 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
enable red ports queue
enable red ports <portlist> queue <queue#>
Description
Enables RED on the specified PoS ports.
Syntax Description
Default
By default, RED is disabled.
Usage Guidelines
The
queue
keyword has been added to support the PoS module. Currently, this new keyword is only
applicable to PoS ports. The keyword allows the RED function to be selectively enabled on an
individual queue basis. The
queue
# parameter is an integer in the range [0-7]. If the
queue
keyword is
omitted, then the command applies to all egress queue numbers for the PoS port(s). (RED is not
supported on the ingress queues.)
Example
The following command enables RED for all PHBs except the EF PHB:
enable red ports 2:1-2:2
History
This command was modified in an ExtremeWare IP Technology Services Release based on v6.1.5b20 to
support PoS modules.
Platform Availability
The general form of this command is available on all platforms. The optional queue parameter is
available only on the PoS module on a BlackDiamond switch.
portlist Specifies the port number(s).
queue# Specifies the queue for which the RED function is enabled.
To Next Page
Loading...
Need help?
General
