disable transceiver-test
ExtremeWare Software 7.3.0 Command Reference Guide 685
disable transceiver-test
disable transceiver-test [all | slot <slot number> {backplane} | msm-a |
msm-b]
Description
Disable the integrity testing of the transceivers used for communication between the ASICs and the
CPU on an MSM or an SMMi module.
Syntax Description
Default
Disabled.
Usage Guidelines
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
show switch
command. The following is sample transceiver test output:
Transceiver Diag: Enabled. Failure action: log only
To display the transceiver test statistics, use the
show diagnostics sys-health-check
command. The
following is sample output:
Transceiver system health diag result
Pass/Fail Counters Are in HEX
Slot Cardtype Cardstate Test Pass Fail Time_last_fail
---- -------- --------- ---- -------- -------- --------------
slot 1 Unknown
slot 2 Unknown
slot 3 FM8V Operational MAC 2b81b 0
slot 4 GM4X Operational MAC 2b81b 0
BPLNE SMMI Operational UART 2b81a 0
BPLNE SMMI Operational FLASH 2b81a 0
BPLNE SMMI Operational SRAM 2b81a 0
BPLNE SMMI Operational NVRAM 2b81a 0
BPLNE SMMI Operational ENET 2b81a 0
BPLNE Basbrd Operational QUAKE 2b81a 0
BPLNE Basbrd Operational TWISTER 2b81a 0
all Specifies all of the slots in the chassis.
slot number Specifies a single slot in the chassis.
backplane Specifies the backplane of the chassis. This is available on Alpine switches
only.
msm-a Specifies the MSM module installed in slot A. This is available on
BlackDiamond switches only.
msm-b Specifies the MSM module installed in Slot B. This is available on
BlackDiamond switches only.
To Next Page
Loading...
Need help?
General
