Extreme Networks ExtremeWare - Disable Diffserv Ingress Replacement Ports

disable diffserv ingress replacement ports
ExtremeWare Software 7.3.0 Command Reference Guide 1875
disable diffserv ingress replacement ports
disable diffserv ingress replacement [high-priority | low-priority |
low-and-high-priority] ports [<portlist> | all] {<Ingress QOS profile>}
Description
Disables the optional overwriting of the DiffServ code point portion of the (IP TOS) field for ingress
traffic.
Syntax Description
Default
Disabled.
Usage Guidelines
The
“3”
series I/O modules support eight ingress QoS profiles (IQP1 - IQP8).
You can disable replacement for high-priority, low-priority, or low- and high-priority traffic for all
ingress QoS profiles on the specified ports or a selected ingress QoS profile on the specified ports.
Example
The following command disables low-priority DiffServ replacement for all
“3”
series ports in all ingress
QoS profiles:
disable diffserv ingress replacement low-priority ports all
History
This command was first available in ExtremeWare 7.1.
Platform Availability
This command is available on
“3”
series I/O modules only.
high-priority Specifies DiffServ replacement for high-priority traffic (traffic received below
the committed-rate configured for the Ingress QoS profile).
low-priority Specifies DiffServ replacement for low-priority traffic (traffic received above the
committed-rate configured for the Ingress QoS profile).
low-and-high-priority Specifies DiffServ replacement for both high-priority and low-priority traffic.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
all Specifies all
“3”
series ports.
Ingress QoS profile Specifies an optional ingress QoS profile: IQP1 through IQP8