Extreme Networks ExtremeWare - Configure Mpls Add Vlan

configure mpls add vlan
ExtremeWare Software 7.3.0 Command Reference Guide 1761
configure mpls add vlan
configure mpls add vlan [<vlan name> | all] {ldp | rsvp-te}
Description
Enables LDP or RSVP-TE for one or all VLANs.
Syntax Description
Default
N/A.
Usage Guidelines
MPLS must be enabled on all VLANs that transmit or receive MPLS-encapsulated frames. Using the
configure mpls add vlan command causes the LDP neighbor discovery process to begin on the
specified VLAN.
NOTE
The specified VLAN must be configured with an IP address and must have IP forwarding enabled.
IGMP snooping must also be enabled on the switch.
If all VLANs are selected, MPLS is enabled on all VLANs that have an IP address and IP forwarding
enabled.
If you have enabled MPLS on an OSPF interface that is used to reach a particular destination, make sure
that you enable MPLS on all additional OSPF interfaces that can reach that same destination (for
example, enable MPLS on all VLANs that are connected to the backbone network).
Example
The following command enables RSVP-TE on vlan1:
configure mpls add vlan vlan1 rsvp-te
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
ldp Enables LDP.
rsvp-te Enables RSVP-TE.