1760 ExtremeWare Software 7.3.0 Command Reference Guide
MPLS Commands
To add a dynamic labeled TLS tunnel (martini-draft compliant), use the following command:
configure mpls add tls-tunnel <tunnel_name> [lsp <lsp_name> | <ipaddress> |
<host_name>] <local_vlan_name> vcid <vcid> <groupid>
The
<tunnel_name>
parameter is a character string that is to be used to identify the TLS tunnel within
the switch. It must begin with an alphabetic character and can contain up to 31 additional alphanumeric
characters.
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
To Next Page
Loading...