754 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
unconfigure sflow collector
unconfigure sflow collector [<ip-address> | all]
Description
Removes the IP addresses of a selected sFlow collector so that sampled flows are no longer sent to that
collector.
Syntax Description
Default
N/A.
Usage Guidelines
This command removes the IP address of one or all configured sFlow collectors. No counters or flow
samples will be sent to these collectors.
Example
The following command removes IP addresses of all configured sFlow collectors:
configure sflow collector all
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
ip-address Specifies the IP address of configured collector to reset.
all Specifies the IP addresses of all configured collectors to reset.
To Next Page
Loading...