Extreme Networks ExtremeWare - Configure Debug-Trace Ipxgns-Message

configure debug-trace ipxgns-message
ExtremeWare Software 7.3.0 Command Reference Guide 2159
configure debug-trace ipxgns-message
configure debug-trace ipxgns-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for IPX GNS message errors to 3:
configure debug-trace ipxgns-message 3
Following is the log output at this level:
<DBUG:XSAP> SAP Traverse: Stuffing entry into packet
<DBUG:XSAP> SAP Traverse: Ignoring type 0278
<DBUG:XSAP> SAP Traverse: Ignoring type 026b
<DBUG:XSAP> SAP Traverse: Ignoring type 0640
<DBUG:XSAP> SAP Traverse: Ignoring type 0278
<DBUG:XSAP> SAP Traverse: Ignoring type 026b
<DBUG:XSAP> SAP Traverse: Ignoring type 0640
<DBUG:XSAP> type 0004 net: 3646f895 mac: 00:90:27:a1:44:3c socket: 1105
<DBUG:XSAP> SAP Traverse: Stuffing entry into packet
<DBUG:XSAP> last message repeated 9 times
<DBUG:XSAP> Rcv bcast GNS type(3) from (f0003606, 00:a0:c9:59:a4:5e) for service=0x4
History
This command was first available in ExtremeWare 6.1.
debug level Specifies a debug level:
0 — None.
1 — None.
2 — Verifies that IPX GNS messages are being sent and received.
3 — Verifies the contents of the messages.
4 — No additional information recorded.
5 — No additional information recorded.
vlan name Specifies a VLAN name.