show wireless ports interface client-scan status
ExtremeWare Software 7.3.0 Command Reference Guide 2093
show wireless ports interface client-scan status
show wireless ports [<portlist> | all] interface [1 | 2] client-scan status
Description
Displays the overall operation of the client scan results.
Syntax Description
Default
N/A.
Usage Guidelines
The output of this command displays the performance results for the following variables on a per
wireless interface basis:
Examples
The following example displays the performance results for port 5 on interface 1:
show wireless ports 5 interface 1 client-scan status
It produces output similar to the following:
Intf Table-Size WaterMark Overflows Timeouts LastElement Total-Probes
-------------------------------------------------------------------------------
5:1 0 0 0 0 0 0
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
Variable Description
CurrentTableSize The current size of the table (in entries)
TableWatermark The maximum size the table has been since the last reset of the
historical statistics
TotalOverflows The number of times an entry has been overwritten because the
table is full
TotalTimeouts The number of times an entry has been aged out from the table
LastElement The last time an element was added to the table
TotalProbes The total number of probes received on this interface
To Next Page
Loading...
Need help?
General
