234 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
configure port aggregate-bandwidth percent
configure port <portnumber> aggregate-bandwidth percent <bandwidth>
Description
Controls the egress bandwidth of a particular port by restricting it to the specified percentage.
Syntax Description
Default
The default percentage of egress bandwidth of a port is 100%.
Usage Guidelines
Port aggregate bandwidth control lets you control aggregate bandwidth of all queues of a specific port.
This feature is useful if you use several queues for classifying traffic (e.g., importance, delay sensitivity,
burst) and you want to restrict total bandwidth for all queues to a certain amount, while preserving the
previously classified queues’ configuration.
Example
The following command restricts the egress bandwidth of port 3 on slot 1 to 20%.
configure port 1:3 aggregate-bandwidth percent 20
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
portnumber Specifies a port or slot and port.
bandwidth Specifies a percentage number (1-99) of restricted aggregate bandwidth.
To Next Page
Loading...