1748 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
show ppp info
show ppp info {<portlist>}
Description
Displays the PPP connection status for selected WAN ports.
Syntax Description
Default
By default, the command displays PPP connection status for all WAN ports.
Usage Guidelines
The
portlist
parameter can be used to specify the port(s) for which PPP connection status is to be
shown. Alternatively, you can enter
show ppp info
with no parameters to obtain PPP connection
status for all WAN ports.
Example
The following command displays PPP connection status for all WAN ports:
show ppp info
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed. A
similar command is available on the BlackDiamond switch.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...