show snmpv3 target-params
ExtremeWare Software 7.3.0 Command Reference Guide 209
show snmpv3 target-params
show snmpv3 target-params {{hex} <param name>}
Description
Display the information about the options associated with the parameter name.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display entries from the SNMPv3 snmpTargetParamsTable. This table specifies the
message processing model, security level, security model, and the storage parameters for messages to
any target addresses associated with a particular parameter name.
If no parameter name is specified, all the entries are displayed.
Example
The following command displays the target parameter entry named P1:
show snmpv3 target-params P1
History
This command was first available in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
param name Specifies the parameter name to display.
To Next Page
Loading...
Need help?
General
