1676 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
delete aps
delete aps <group#>
Description
Deletes the specified APS group.
Syntax Description
Default
N/A.
Usage Guidelines
You specify the
group#
parameter, which is an integer in the range [1-65535]. The
group#
identifies the
APS group to delete.
Example
The following command example deletes APS group 1001:
delete aps 1001
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
group# Specifies the APS group# to which the command applies.
To Next Page
Loading...