426 ExtremeWare Software 7.3.0 Command Reference Guide
NAT Commands
configure nat finrst-timeout
configure nat finrst-timeout <seconds>
Description
Configures the timeout for a TCP session that has been torn down or reset.
Syntax Description
Default
Default timeout is 60 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed-out. This is not
normally recommended as NAT resources will get used up.
Example
The following command configures the timeout for a reset or torn-down TCP session to 120 seconds:
configure nat finrst-timeout 120
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
seconds Specifies the number of seconds to wait before the session table entry times
out.
To Next Page
Loading...