configure nat udp-timeout
ExtremeWare Software 7.3.0 Command Reference Guide 431
configure nat udp-timeout
configure nat udp-timeout <seconds>
Description
Configures the timeout for a UDP session.
Syntax Description
Default
Default timeout is 120 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed-out. This is not
normally recommended as NAT resources will get used up.
Example
The following command configures the timeout for a UDP session to 90 seconds:
configure nat udp-timeout 90
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
seconds Specifies the number of seconds to wait before the session table entry times
out.
To Next Page
Loading...