792 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
configure radius server
configure radius [primary | secondary] server [<ipaddress> | <hostname>]
{<udp_port> <L4 port no>} client-ip [<ipaddress>]
Description
Configures the primary and secondary RADIUS authentication server.
Syntax Description
Default
The default UDP port setting is 1645.
Usage Guidelines
Use this command to specify RADIUS server information.
Use of the <hostname> parameter requires that DNS be enabled.
The RADIUS server defined by this command is used for user name authentication and CLI command
authentication.
Example
The following command configures the primary RADIUS server on host
radius1
using the default UDP
port (1645) for use by the RADIUS client on switch 10.10.20.30:
configure radius primary server radius1 client-ip 10.10.20.30
History
This command was first available in ExtremeWare 4.1.
Platform Availability
This command is available on all platforms.
primary Configures the primary RADIUS authentication server.
secondary Configures the secondary RADIUS authentication server.
ipaddress Specifies the IP address of the server being configured.
hostname Specifies the host name of the server being configured. Must be able to be
resolved to an IP address.
udp_port Specifies UDP port to use to contact the RADIUS authentication server.
ipaddress Specifies the IP address used by the switch to identify itself when
communicating with the RADIUS authentication server.
L4 port no Specifies the L4 port used to contact the RADIUS server.
To Next Page
Loading...